Technical Specifications - Velleman CCTVPROM17 Kurzanleitung

10.2 Enabling Push Video
From iPhone or iPad
1. In the iPhone/iPad main menu, select Settings > Notifications.
2. Select EagleEyes and make sure Notification Center is set to ON.
3. Open EagleEyes and switch the Push Video button to ON. You receive a message that push notification (push video) is
enabled.
4. Return to the main menu of your iPhone/iPad.
You receive event notifications when there is an alarm event. Select Launch to play the recorded clip immediately.
From Android Mobile Device
In the address book, switch Guard from OFF to ON.
11.

Technical Specifications

video format
video compression
video input
video output
video loop out
maximum recording rate
(PAL)
adjustable recording speed
image quality setting
hard disk storage
recording mode
refresh rate
multiplex operation
audio I/O
motion detection area
motion detection sensitivity
pre-alarm recording
backup device
V. 03 – 05/05/2014
CCTVPROM17
PAL
H.264
8 channels, composite video signal 1 Vpp / 75 ohm BNC
composite video signal 1 Vpp / 75 ohm BNC
VGA max. 1600 x 1200 pixels
HDMI max. 1600 x 1200 pixels
–
frame 704 × 576 pixels @ 100 fps (PAL)
CIF 352 × 288 pixels @ 200 fps (PAL)
–
best – high – normal – basic
built-in SATA type, supports 1 x HDD, supported HDD capacity 2 TB (HDD not incl.)
manual / timer / motion / network / alarm
200 IPS for PAL
live display, record, playback, backup and network
4 x audio in, 1 x audio out (mono)
16 × 12 grids per channel
high, normal, low
8 MB
USB 2.0 flash drive (for backup and firmware updates)
9 ©Velleman nv