Preliminary Settings - Velleman CCTVPROM17 Kurzanleitung

6.

Preliminary Settings

Make sure the connected cameras are on and set the power switch at the rear of the device to the on position. The device
takes about 15 to 30 seconds to start up.
Menu Overview
1. Press the MENU button and enter the password to open the menu.
Note: The default admin password is "0000" (4 times zero).
2. Right-click anywhere on the screen to open the main menu. Right-click again to close.
QUICK START
DATE SETUP
SYSTEM
EVENT INFORMATION
ADVANCED CONFIG
SCHEDULE SETTING
For more information, refer to the full user manual.
Date and Time Setting
Before operating your DVR, please set the date and time on your DVR first.
Note: DO NOT change the date or time of your DVR after the recording function is activated. Otherwise, the recorded data
will be disordered and you will not be able to find the recorded file from backup by time search. If users change the date or
time accidentally when the recording function is activated, it is recommended to clear all HDD data, and start recording again.
Note: When using the DVR for the first time, leave it powered on for at least 48 hours continuously after the date and time is
set correctly. It prevents DVR time from resetting if the DVR power is disconnected. If the DVR time resets after power
disconnection (for example caused by a power outage), the internal battery may run down. In that case, you have to replace
the internal battery. Please refer to the appendices in the full user manual for more information.
1. Press the MENU button and enter the admin password to open the menu.
2. Select the QUICK START menu item.
3. Use the NAVIGATION button to move to the TIME SETUP menu item. Select it to set date and time.
Password Setting
1. Press the MENU button and enter the password to open the menu.
2. Select the SYSTEM menu item.
3. Go to TOOLS. Select ADMIN PASSWORD (or OPERATOR PASSWORD) and press the ENTER button to set the password.
Note: An operator cannot access the main menu, only the quick menu bar (see below).
4. Press the cursor up (
the next character, or use the mouse to select the desired value. Repeat this for all four password numbers.
Note: The default admin password is "0000" (4 times zero).
Record Settings
1. Press the MENU button and enter the password to open the menu.
2. Select the QUICK START menu item.
3. Select the GENERAL menu item using the NAVIGATION button.
4. Set the image size, image quality, and images per second for recording.
Refer to the full user manual on the included CD-ROM for more details.
Audio Playback
Press the SLOW and ZOOM button simultaneously to select the desired audio channel or use the quick menu bar (see further
in this manual). The current audio channel is indicated in the status bar.
Switching Users
1. The DVR can be accessed as administrator (
2. To switch between users, click on the user icon (
3. Press on the key lock icon (
V. 03 – 05/05/2014
GENERAL – TIME SETUP
DATE INFO – DAYLIGHT
TOOLS – SYSTEM INFO
QUICK SEARCH – EVENT SEARCH – HDD INFO – EVENT LOG
CAMERA – DETECTION – ALERT – NETWORK – SNTP – DISPLAY – RECORD – REMOTE
RECORD – DETECTION
) or down ( ) button to select the value of the first number and press ENTER to save and go to
) or operator (
or
) then enter the password of the desired profile.
CCTVPROM17
), icons are indicated in the status bar.
) to lock the current session (
5
).
©Velleman nv