File Backup - Velleman CAMIP16 Bedienungsanleitung

Notes
The system will ask if you want to keep current configurations. It is recommended to keep them. If not, all
•
configurations will be restored to factory settings after the firmware upgrade.
• It takes a few minutes to finish the upgrade process. Do not disconnect the power during firmware upgrade,
or the upgrade may be failed. The camera will reboot after the upgrade.
2.

File Backup

You can backup recorder files:
• with the Video Viewer software
with internet explorer 32 bits
•
using the SD card from the camera in the computer.
•
2.1 Back up files with Video Viewer
1. Open the Video Viewer software.
If you don't have the Video Player software, you can download and install it from the CAMIP16 product page
on www.velleman.eu.
2. Select the appropriate camera in the address book and click Edit.
3. Under Config > Record:
Set Enable to Yes.
o
Set Overwrite to Yes.
o
Set the record resolution to HD1080P.
o
4. Under Trigger, set the motion detection, as shown:
V. 01 – 24/04/2014
CAMIP16
3 ©Velleman nv