Troubleshooting - Stocker 580 Benutzerhandbuch

Art. 580 / Art. 581 / Art. 584 / Art. 585
8
Problems Causes
The tool connected to the 1. Broken wires or blown
handle does not work. solder inside handle.
The telescopic lock system 1. Breakage or loss of a
does not work. piece of the locking system
Inner tube slips off the outer
1. Latch is missing
one
The handle cannot be
1. Twisted cable
lengthened or shortened.
If shears or chainsaw do not works when used with the handle, the problem is not with the hand-
le but with the tool used, caused by incorrect welding which does not allow correct wiring. In this
case, send the tool to repair service center by local authorized reseller or Stocker Srl.
56
Magma telescopic handles

Troubleshooting

Solutions
1. Send to repair service
center by local authorized
reseller or Stocker Srl.
1. Replace the locking system
piece. Contact the local
reseller or Stocker srl to
request spare parts or send
the product for repair to a
local authorized reseller or
Stocker Srl.
1. Add the appropriate screw
to prevent the problem from
happening again. Contact your
local reseller or Stocker srl to
request spare parts.
1. Send to repair service
center by local authorized
reseller or Stocker Srl.
Art. 580 / Art. 581 / Art. 584 / Art. 585
Magma telescopic handles
For further information about the product, please contact info@stockergarden.com
57