Cleaning And Maintenance; Cleaning The Outside Of The Device; Replacement Of Filters - Clean Air Optima CA-508 Bedienungsanleitung

Cleaning the outside of the device

1. Switch off the device and pull the plug.
2. Use a soft and humid piece of cloth to clean the device from dust and dirt.
3.
Make sure that no water gets into the device.

Replacement of filters

The Clean Air Optima air purifier CA-508 is equipped with a filter monitor that shows when the filters
need to be replaced. When the moment of replacement has come, the air purifier will make a 30
seconds long sound after which the HEPA RESET lamp will lighten up. Replace the filters according
to the instructions below. Restart the air purifier by resetting: after the replacement of the filters,
insert the top of a pen into the HEPA RESET area on the control panel to restart the system.
1. Switch out the device and pull the plug.
2. Press on the release button and remove the rear cover.
3. Remove the used activated carbon pre-filter.
4. Remove the used HEPA filter from the device.
5. Unpack the new filters.
6. Position the HEPA filter into the purifier (pay attention to the arrow on the filter for the correct
direction).
7. Position the activated carbon filter into the back part of the device.
8. Position the rear cover and press until it snaps.

Cleaning and maintenance

7