Maintenance, Overhaul, Repair; Maintenance; Overhaul; Repair - Stahl 9418-Serie Betriebsanleitung

Maintenance, Overhaul, Repair

EN
11 Maintenance, Overhaul, Repair
EN
EN

11.1 Maintenance

• Consult the relevant national regulations to determine the type and extent of
EN
inspections.
EN
• Adapt inspection intervals according to the operating conditions.
EN
EN At a minimum, check the following points during maintenance work on the device:
• whether the clamping screws holding the cables are securely seated
EN
• the device and the connection lines for visible damage,
EN
• whether the permissible ambient temperatures are observed,
EN
• whether the device is used according to its designated use.
EN

11.2 Overhaul

EN
EN
EN
EN
EN
EN

11.3 Repair

EN
EN
EN
EN
EN
EN

11.4 Returning the Device

EN
• Only return or package the devices after consulting R. STAHL!
EN
Contact the responsible representative from R. STAHL.
R. STAHL's customer service is available to handle returns if repair or service is required.
• Contact customer service personally.
or
• Go to the r-stahl.com website.
• Under "Support" > "RMA" > select "RMA-REQUEST".
• Fill out the form and send it.
You will automatically receive an RMA form via email. Please print this file off.
• Send the device along with the RMA form in the packaging to
R. STAHL Schaltgeräte GmbH (refer to chapter 1.1 for the address).
14
Fieldbus Terminator
Series 9418
Observe the relevant national regulations in the country of use.
Explosion hazard due to improper repair!
Non-compliance results in severe or fatal injuries.
• Repair work on the devices must be performed only by
R. STAHL Schaltgeräte GmbH.
DANGER
166532 / 941860310010
2020-11-06·BA00·III·en·05