Herunterladen Inhalt Inhalt Diese Seite drucken

Tesla RoboStar iQ400 Plus Bedienungsanleitung Seite 22

Vorschau ausblenden Andere Handbücher für RoboStar iQ400 Plus:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 26
tool to remove hair tangled in the main brush. Keep the center cleaning brush free of large amounts of
hair, dust, cotton, etc. Check both side cleaning brushes together with the air intake hole at least once a
week according to the intensity of dust and remove tangled hair and other dirt from them.
SENSORS, CHARGING CONTACTS AND CHARGING STATION
Connectors of the charging station: Disconnect the power supply and clean the contacts once a month
with a soft, dry cloth.
Front wheel: Use a flat screwdriver to insert under the rubber wheel and remove it with an upward
movement. After cleaning, put it back until you hear a click. Also clean the axle of the wheel.
Floor sensors: Once a week, clean the three sensors on the bottom of the robotic vacuum cleaner with
a soft, dry cloth. Check that the front bumper, under which the impact sensor is located, is not blocked.
TROUBLESHOOTING
Problem
The robotic vacuum cleaner
behaves "chaotic".
After installing the application
and pairing the mobile phone
with the robotic vacuum cleaner,
the vacuum cleaner is "Not
connected".
The robotic vacuum cleaner does
not start cleaning.
The robotic vacuum cleaner
cannot be charged.
The robotic vacuum cleaner does
not return to the charging base.
Solution
Always place the vacuum cleaner in the charging station before
starting cleaning.
Turn your Wi-Fi router on and off, remove your robot vacuum in
the app, and try to pair it again. We recommend always being
close to the Wi-Fi router during pairing.
1. The robotic vacuum cleaner has a weak battery. Charge the
battery to full capacity before starting cleaning.
2. The battery is too hot. Use the robotic vacuum cleaner in
temperatures of 0°C ~ 40°C.
1. The charging station is not connected to the network. Make
sure the power cord is properly connected.
2. The charging electrodes have bad contact with the robotic
vacuum cleaner. Clean the electrodes on the robotic vacuum
cleaner and on the charging base.
Make sure there is enough space around the charging station
and the detection zone of the charging station is clean.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Robostar iq400

Inhaltsverzeichnis