Install The Battery Pack; Remove The Battery Pack; Adjust The Harness; Remove The Harness - GreenWorks GD60BPB Bedienungshandbuch

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2 OVERVIEW
Figure 1 - 5.

1 Turbo button

2 Cruise control lever

3 Trigger
4 Front blower tube
5 Rear blower tube
2 SAFETY
Make sure that you follow all safety instructions.
Refer to Safety Manual.
2.1 GENERAL POWER TOOL SAFETY
WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool.Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
6 Connecting tube
7 Battery release button
8 Battery compartment
9 Harness
WARNING
WARNING
WARNING
WARNING
English
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 INSTALL THE TRIGGER HANDLE
Figure 2 -3.
1. Move the trigger handle (11) onto the connecting tube
(6).
2. Use knob to tighten the screw.
3.3 INSTALL THE CONNECTING
TUBE
Figure 4 - 6.
1. Align the rib (12) on the connecting tube with the slot
(13) in the flexible tube.
2. Put the end of the connecting tube (6) into the flexible
tube.
3. Push the connecting tube into the flexible tube.
4. Put the hose clamp (14) around the flexible tube.
5. Install and tighten the available screw into the hose clamp
(14).
3.4 INSTALL THE REAR BLOWER
TUBE
Figure 7 - 8.
1. Align the grooves on the rear blower tube (5) with the
tabs on the connecting tube (6).
2. Turn the rear blower tube in the direction of the slot until
the tabs lock into position.
Put the cord in the cord retainer.
3.5 INSTALL THE FRONT BLOWER
TUBE
Figure 9 - 10.
1. Align the grooves on the front blower tube (4) with the
tabs on the rear blower tube (5).
2. Install the front blower tube onto the rear blower tube
until the tabs engage the grooves.
3. Turn the front blower tube in the direction of the slot until
the tabs lock into position.
The front tube has two fixed positions. You can adjust the
length of the tube according to different needs.
4
WARNING
NOTE