Changing The Demo Project Sound - PIONEER DJ TSP-16 Bedienungsanleitung

2 Tap [ARRANGEMENT].
[ARRANGEMENT] lights. In this state, patterns are played in the order in
which they were sorted in this screen.
3 Press the [d] button.
The [d] button lights in green and the arrangement of the demo project
plays. The playback icon (d) is displayed in the column of the currently
playing pattern on the touch display.

Changing the demo project sound

Step modulation
1 Tap the track which you wish to change and tap again
to enter.
The track menu screen appears.
! You can also go to the track menu screen by turning the rotary selec-
tor to select a track and then pressing the rotary selector.
10
En
2 Tap [PLAYBACK] and tap again in the selected state.
The playback screen appears.
! You can also go to the track menu screen by turning the rotary selec-
tor to select [PLAYBACK] and then pressing the rotary selector.
3 Turn the parameter 1 adjustment knob while pressing
the 16-step key [13].
Now, the pitch of the sample will change only at the fourth beat.
! Other steps and other parameters can be changed with the same
operation.
Analog filter
Use the dials to sculpt your sound – manipulating Drive, Cut Off and
Resonance – and add true analogue warmth and presence.
1 Press the [ACTIVE] button.
The analog filter effect is enabled (activated). In the active state, the
button is lit in red.
2 Turn the [LOW PASS CUTOFF] control.
The low-pass filter's cutoff frequency changes.
! Turning the control counterclockwise moves the cutoff frequency
toward the lower frequencies, and turning it clockwise moves the
cutoff frequency toward the higher frequencies.
3 Turn the [LOW PASS RESONANCE] control.
The low-pass filter's resonance changes.
! Turning the control counterclockwise reduces the resonance of
sound in the vicinity of the cutoff frequency, and turning it increases
the resonance.
4 Turn the [HIGH PASS CUTOFF] control.
The high-pass filter's cutoff frequency changes.
! Turning the control counterclockwise moves the cutoff frequency
toward the lower frequencies, and turning it clockwise moves the
cutoff frequency toward the higher frequencies.
5 Turn the [DRIVE] control.
The analog filter's drive amount is adjusted.
! Turning the control counterclockwise reduces the effect, and turning
it clockwise increases the effect.
! If the effect is made large, the output sound may be distorted. When
that happens, the OVER indicator lights in amber so that you can
know that a distortion effect is occurring due to the analog filter
circuit.