Appliance Handover; Cleaning And Maintenance - STIEBEL ELTRON ULTRONIC Plus Bedienung Und Installation

INSTALLATION

Cleaning and maintenance

f Press the appliance against the wall and slowly push the ap-
pliance down as far as it will go.
f On the underside of the appliance, fasten the locking screw
into the wall mounting bracket using the provided Torx key.
f Switch on the power supply or insert the mains plug on the
power cable, if fitted, into the standard safety socket.
The LED on the front of the appliance flashes red three times, then
lights up white. The unit is ready for operation.
f Check the appliance function.

10.8 Appliance handover

f Explain the functions of the appliance to the user.
f Draw special attention to the safety instructions.
f Hand over these operating and installation instructions to the
user.
11. Cleaning and maintenance
WARNING Electrocution
Before any work on the appliance, disconnect all poles
from the power supply.
f Before starting any cleaning and maintenance work, remove
the appliance from the wall mounting bracket.
www.stiebel-eltron.com
1.
f Undo the locking screw on the underside of the appliance
using the provided Torx key.
f Lift the appliance off the wall mounting bracket.
f Make sure that the LED on the front of the appliance is off
before you open the appliance.
ULTRONIC Plus | ULTRONIC Premium |
2.
43