Wall Mounting; Fitting The Htt 4 Casing Cover; Fitting The Htt 5 Casing Cover; Appliance Handover - STIEBEL ELTRON HTT 4 Bedienungsanleitung

INSTALLATION

APPLIANCE HANDOvER

1
2
3
1 Casing cover
2 Locking slide
3 Locking screw
9.3

Wall mounting

Cut out the drilling template. This can be found at the end of
»
these instructions.
Transfer the four mounting points on to the wall using the drilling
»
template. Pay attention to the length and position of the power
cable. Use our height guidelines to help you (see Specification).
Drill the fixing holes and insert rawl plugs.
»
Insert the lower fixing screws into the wall.
»
1
1 Cable entry
16 | HTT 4-5
Pull the power cable through the cable entry in the back panel
»
of the appliance.
Fit the appliance with the keyhole fixings on to the fixing screws.
»
Secure the appliance to the wall using two more screws.
»
Connect the power cable to the appliance.
»
Note!
Ensure that the wires of the power cable are not near
the fan motor.
Note!
Observe the maximum length of the power cable.
(See Specification)
9.4

Fitting the HTT 4 casing cover

Place the casing cover on the appliance so that it is slightly tilted
»
and pivot it towards the wall.
Push the locking slide up as far as it will go.
»
Secure the locking slide and the casing cover with screws.
»
9.5

Fitting the HTT 5 casing cover

Slide the casing cover, slightly tilted, over the appliance towards
»
the wall as far as it will go. Ensure that the hooks provided on
the bottom of the casing cover catch behind the back panel of
the appliance.
To lock in place, lift the casing cover slightly at the front and
»
push the locking slide up as far as it will go.
Secure the locking slide with screws.
»
10. Appliance handover
Explain the functions of the appliance to the user. Draw special
attention to the safety information. Hand the operating and
installation instructions to the user.
WWW.STIEBEL-ELTRON.COM