Included Items; Conventions Used In This Manual; Precautions For Placement And Use; Notes About Power Supplies - Tascam SB-16D Bedienungsanleitung

Included items

This product includes the following items.
Take care when opening the package to avoid damaging the
items. Keep the packing materials for transportation in the
future.
Please contact the store where you purchased this unit if any
of these items are missing or have been damaged during
transportation.
o Main unit ................................................................................................x 1
o Power cords (for Japan/USA, Europe and Oceania) ................x 3
o Rackmount ear (with installation screws) set ...........................x 1
o Rackmount screw kit ..........................................................................x 1
o TASCAM ID registration guide ........................................................x 1
o Owner's Manual (this document) including warranty ...........x 1

Conventions used in this manual

In this manual, we use the following conventions:
o Additional information is introduced in the styles below
when needed:
TIP
These are tips about how to use the unit.
NOTE
These provide additional explanations and describe special
cases.
ATTENTION
Failure to follow these instructions could result in damage to
equipment or lost data, for example.
V CAUTION
Failure to follow these instructions could result in injury.

Precautions for placement and use

o The operating temperature range of this unit is 0 - 40 °C.
o Do not install this unit in the following types of locations.
Doing so could make the sound quality worse or cause
malfunction.
Places with significant vibrations
Next to a window or in another location exposed to direct
sunlight
Near heaters or other extremely hot places
Extremely cold places
Very humid or poorly ventilated places
Very dusty places
o Do not block the ventilation ports, which dissipate heat, on
the back and sides of the unit.
o To enable good heat dissipation, do not place anything on
top of the unit.
o Do not place the unit on top of a power amplifier or other
device that generates heat.

Notes about power supplies

o Insert the included power cord all the way into the AC IN
connector.
o Only connect a power supply that is AC100-240V (50/60Hz)
to the AC IN connector.
o Only connect a power supply that is DC 11V–27V to the EXT
DC IN connector. Use a power supply that has a 11V–27V
Limited Power Source (LPS) rating for output voltage with the
EXT DC IN connector.
o Hold the power cord by its plug when connecting or
disconnecting it.
ATTENTION
If you want to completely cut off the power supply to the
stagebox, always remember to disconnect it from both
power sources.
NOTE
This product includes 3 types of power cords. Use the power
cord that matches the type of power outlet being used.

Beware of condensation

Condensation could occur if the unit is moved from a cold place
to a warm place, it is used immediately after a cold room has
been heated or it is otherwise exposed to a sudden temperature
change.
To prevent this, or if this occurs, let the unit sit for one or two
hours at the new room temperature before using it.

Cleaning the unit

Use a dry soft cloth to wipe the unit clean. Do not wipe
with chemical cleaning cloths, thinner, alcohol or other
chemical agents. Doing so could damage the surface or cause
discoloration.
About TASCAM customer support
service
TASCAM products are supported and warrantied only in their
country/region of purchase.
To receive support after purchase, on the TASCAM Distributors
list page of the TEAC Global Site (https:// teac-global.com/),
search for the local company or representative for the
region where you purchased the product and contact that
organization.
When making inquiries, the address (URL) of the shop or
web shop where it was purchased and the purchase date are
required.
Moreover, the warranty card and proof of purchase might also
be necessary.
7
TASCAM SB-16D