Redundant Connection; Using Dante Controller; Dante Controller Overview; Audio Routing Settings - Tascam SB-16D Bedienungsanleitung

Redundant connection

For recording situations where retakes are not possible,
including live performances, a connection set up like the
following uses two completely independent primary and
secondary networks.
Redundant connection example
Primary
PC
HUB
NOTE
Settings for switched (daisy chain) and redundant
connections do not change automatically. Change the
settings on the Dante Controller Network Config screen.
ATTENTION
The primary and secondary networks can never be
connected to each other by the same LAN (VLAN).
Primary
14
TASCAM SB-16D
Secondary
Mixer
SB-16D HUB
SB-16D
Hub
Secondary

Using Dante Controller

Dante Controller overview

This unit uses the Dante Controller application, which is
available at the Audinate website, to connect with other devices
that support Dante.
Download the latest version of the Dante Controller application
and an operation manual from the Audinate website.
Audinate download page
https://www.audinate.com/products/software/dante-
controller
Make at least the following settings using a computer that has
Dante Controller installed.
o Set the audio routing.
o Adjust the sampling frequency and bit depth of each Dante
device.
NOTE
Settings made using Dante Controller are stored in the built-
in memory of each Dante device.
Unless settings are modified, connections will not
change even if Dante Controller is quit or the computer is
disconnected from the Dante network.

Audio routing settings

When Dante Controller is launched, the Network View screen
shown below will open.
On this screen, you can set and monitor conditions related to
the Dante network.
1Receiving device name
This is the name of a receiving device on the Dante network.
2Receiving device channels
These are the names of the channels of the receiving device
on the Dante network.
3Transmitting device name
This is the name of a transmitting device on the Dante
network.
4Transmitting device channels
These are the names of the channels of the transmitting
device on the Dante network.