Olympia CPD 512 Bedienungsanleitung Seite 16

Keyboard, Display and Switches
Display
Indicators
-" Minus sign:
M" Memory indicator:
E" Error/Overflow
Switches
Decimal Point Selector
A 0 2 3 4 F
A
F
0,2,3,4
Rounding Selector
á 5/4 â
á
5/4
â
16
Negative results are shown using a minus sign on the display and indicated by
using red writing on the printer.
M" appears on the display to show that a figure is stored in the memory.
E" appears when dividing by zero or when the sign capacity is not sufficient.
Decimal point Selector
Determines the number of decimal points show on the display or the printer.
(Add mode)
Decimal point is automatically set two places to the left in an addition or
subtraction calculation. It is also possible to set the position of decimal point
individually by pressing the decimal point key at the desired position. All results
are given with two positions to the right of the decimal point.
This setting will show floating decimal points (maximum 12).
If the result adds to more than 12 figures, the overflow will be dropped. The
rounding function is switched off in this mode.
Fixed decimal point mode.
This setting determines the number of decimal points to the right of the decimal
point. In this mode, the automatic rounding function is activated.
Rounding switch
Absolute rounding up.
In this setting, figure will automatically be rounded up or down.
If the last figure is followed by a value between 0 and 4, this last figure will
remain unchanged. If this figure is followed by a figure between 5 and 9, this
figure will be rounded up.
Absolute rounding down.