Protect The Environment; Battery Removal; Service & Warranty - Remington HC725 Anleitung

PROTECT THE ENVIRONMENT

BATTERY REMOVAL

SERVICE & WARRANTY
This product has been checked and is free of defects. We warrant this product against any
defects that are due to faulty material or workmanship for a 2 year period from the original
date of consumer purchase. If the product should become defective within the warranty
period, we will repair any such defect or elect to replace the product or any part of it
without charge provided there is proof of purchase. This does not mean an extension of the
warranty period.
In the case of a warranty simply call the Remington
This warranty is offered over and above your normal statutory rights.
The warranty shall apply in all countries in which our product was sold via an authorised
dealer.
This warranty does not include cutters which are consumable parts. Also not covered is
damage to the product by accident or misuse, abuse, alteration to the product or use incon-
sistent with the technical and/or safety instructions required. This warranty shall not apply if
the product has been dismantled or repaired by a person not authorised by us.
6
080881_REM_IFU_HC725_22L.indd GB6 080881_REM_IFU_HC725_22L.indd GB6
ENGLISH
The product contains a Nickel Metal Hydride cell unit. Do not dispose the trimmer in
household waste at the end of its useful life. Disposal can take place at our service centres
or appropriate collection sites.
CAUTION:
Do not put in fire or mutilate your battery packs as they may burst
or release toxic materials.
For further information on recycling see www.remington-europe.com
The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
Ensure that the clipper is discharged of all power and disconnected from the mains.
Lift or pry the screw cover and unscrew I screw located on the back housing of the clipper.
Lift or pry the clipper halves apart, exposing the printed circuit board.
Unscrew the screws on the printed circuit board and turn it around.
Cut the wires on both ends of the battery and remove it from the clipper.
The battery is to be disposed of safely.
® Service Center in your region.
14.11.2008 15:57:17 Uhr 14.11.2008 15:57:17 Uhr