Remington HC725 Anleitung Seite 6

This product has a taper lever located a the left side of the clipper near the blades. Adjust
the lever to change the closeness of the cut gradually and also to improve the effectiveness of
the comb attachments. The taper lever also extends the life of the blades because a different
cutting edge is used in each setting.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fitted with high quality ceramic coated blades that are premanently lubricated.
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
Always keep the protective cap on the trimmer blade.
At regular intervals the Blade Set should be removed and cleaned.
4
080881_REM_IFU_HC725_22L.indd GB4 080881_REM_IFU_HC725_22L.indd GB4
ENGLISH
SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
Starting with the longest guide comb attached (25mm), cut from the back of the neck to
the crown. Hold the guide comb flat against the head and slowly move the clipper through
the hair, as shown. (PICTURE 1)
Use the same procedure from the lower side to the upper side of the head, as illustrated.
Then cut the hair against the direction in which it grows and level with the sides.
(PICTURE 3)
To give a "flat top" look, the hair on top of the head must be cut over the top of a flat
comb.
Use a closer guide comb to taper the hair down to the neckline as desired.
TAPER LEVER
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush the accumulated hair from the blades. Do not submerge the clipper in water.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning.
EVERY SIX MONTHS
Remove the 2 screws retaining the fixed blade with a screwdriver. Do not remove blade
set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fitted by slotting the ceramic coated
blade holder over the pin in the centre of the interior product head. The groove on the
ceramic coated blade, just below the teeth, rests on a metal plate at the opposite side to
the screw holes. The fixed blade is fitted with the raised profile pointing outwards and
fixed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align
14.11.2008 15:57:17 Uhr 14.11.2008 15:57:17 Uhr