Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Description Attachment of the EFOY Fuel Manager hoses:
Insert the cable gland with the EFOY Fuel Manager connections (and the fuel
cartridge sensor cable, if applicable) back into the cable plug rail. The flat side of
the cable plug should be facing up.
Replace the cable plug and close the hole in the side wall of the EFOY ProFuelBox
by replacing the cover (2) and inserting the cable plug through the hole.
Tighten the cable gland again with the large plastic nut (3), which has been pulled
over the four fuel cartridge connections one by one. Make sure that the nut does
not jam. Make sure that the screw connection is tightly closed so that no water can
enter.
Press the cover and the lower half of the cable gland together while
tightening the plastic nut.
Finally, retighten the two screws (1) on the cover of the cable gland (2).
Page 48
Commissioning
Werbung
