Flex DD 2G 18.0-EC LD Originalbetriebsanleitung Seite 16

Symbols used in this manual
WARNING!
Denotes impending danger. Non- observance
of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in
slight injury or damage to property.
NOTE
Denotes application tips and important
information.
Symbols on the power tool
V Volts
/min Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 22)!
For your safety
WARNING!
Before using the power tool, please read the
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged.
The cordless drill driver/hammer drill may be
used only
as intended,
16
DD 2G 18.0-EC LD / PD 2G 18.0-EC LD
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
The cordless drill driver/hammer drill is
intended
– for commercial use in industry and trade,
– for drilling holes, drilling wood, drilling
metal, driving screws and drilling masonry
(this only for hammer drill).
Safety instructions for drill driver/
hammer drill
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
Drill driver
■ Hold the power tool by insulated
gripping surfaces, when performing an
operation where the cutting accessory or
fastener may contact hidden wiring. The
cutting accessory or fastener contacting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock.
■ Secure the work piece. Clamping devices
or a vise will hold the work piece in place
better and more safely than holding it by
hand.
■ Do not drill, fasten or break into existing
walls or other blind areas where
electrical wiring may exist. If this situation
is unavoidable, disconnect all fuses or
circuit breakers feeding this worksite.
■ Position yourself to avoid being caught
between the tool or walls or posts.
Should the bit become bound or jammed
in the work, the reaction torque of the tool
could crush your hand or leg.
■ Always wait until the machine has come
to a complete stop before placing it
down. The tool insert can jam and lead to
loss of control over the power tool.
■ When working with the power tool,
always hold it firmly with both hands
and assume a secure stance. The power
tool is guided more securely with both hands.