Power Down; Source Selection - SPL Diamond Schnellstartanleitung

Diamond – Quickstart
Power up
10
Turn down the volume of the Diamond.
Switch on mains switch on the back of the Diamond (On = I).
11
Power LED is dimly lit.
Operation
Switch the Diamond from standby into operation by setting the standby switch
12
to ON.
Power LED now lights up brightly.
Standby
Switch the Diamond in standby mode by setting the standby switch to
13
( = Standby).
Power LED is dimly lit.

Power down

14
Turn down the volume of the Diamond.
15
Switch off mains switch on the rear of the Diamond (Off = O).
Power LED no longer lights up.

Source selection

Choose a source by turning the Source switch: USB, Coax 1, Coax 2, Optic 1,
16
Optic 2, or AES.
4