Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Inner glass panel removal
Remove both door top corner pieces.
These can be removed by pressing in
the arrow-marked tabs on either side
of the door and sliding the corner pieces
out.
Lift the edge of the inner glass slightly
and then slide it from its lower clips. The
middle glass panel can then also be
removed. Follow these steps in reverse
to replace the glass.
TROUBLESHOOTING
When a failure, conflict or other failure occurs, the time display nixie tube will display some error
codes, and their meanings are as follows:
DISPLAY
No temperature sensor/open
E01
circuit/open circuit
Temperature sensor short
E04
circuit
Long key press error
E06
Important: All repairs must be carried out by qualified personnel.
ERROR
Removal of the internal glass panel
POSSIBLE CAUSE(S)
The control board detects that there is no
temperature sensor, the oven will stop
heating .
The temperature is below -10°C .
A short circuit of the sensor is detected
and the oven stops heating .
After the button is pressed for more than
15 seconds, a buzzersignal will be
generated, and theerror code will be
displayed on the digital tube at the same
time .
Werbung
Inhaltsverzeichnis
