Samsung Jet Bot VR50T95 Serie Benutzerhandbuch Seite 43

Symptom
I fail to log into the SAMSUNG
account.
During product registration,
the wireless router I want to
connect cannot be searched.
During product registration,
the password of the connecting
wireless router is not input
correctly.
During product registration,
[ ] button is pressed and held
as instructed but the next step
does not appear.
A message of the product
registration failure appears.
(Applicable to iOS only) During
product registration, the AP
password 1111122222 is not
input correctly.
The Jet Bot is not connected to
Wi-Fi.
Even though the Jet Bot is
connected to a smartphone
without a problem, the Jet
Bot does not work with the
smartphone.
The Jet Bot on the SmartThings
App fails to start.
• Check your ID and password on the screen of the
SAMSUNG account.
• Cancel the product registration, run the SmartThings App
again, and try the product registration again.
• Cancel the product registration, run the SmartThings App
again, and try the product registration again.
• Press and hold the wireless router you want to connect
on the network list, and delete the network to initialize
the password.
• Press the [ ] button until you hear it beep.
• If the next step does not appear within several seconds,
press the [ ] button one more time.
• In the case of iOS, hold down the [
Jet Bot for at least 3 seconds and then select the 'Next'
button on the screen.
• Try the product registration procedure again by
referring to the pop-up messages.
• Please refer to the "Setting up the wireless router" in the
user manual.
• Please refer to the steps for completing the product
registration in the user manual section "Adding a device
to the SmartThings App".
• When the product registration fails repeatedly, restart
the SmartThings App and try the product registration.
• All users should use the SAMSUNG account issued by the
country which launches the product.
• Press and hold the "[vacuum]_E30AJT**" on the network
list and delete the network to initialize the password.
• Check the setting status of the wireless router.
• Turn off the SmartThings App and then run it again, or
disconnect the smartphone from the wireless router and
then connect it again, or turn off the power supply of
the Jet Bot, turn it on, wait for a minute or longer, and
then run the SmartThings App again.
• Check if the Jet Bot is offline status on the SmartThings
App.
• Connect the wireless router to Jet Bot again by referring
to the 'SmartThings App' on the manual.
Checklist
] button on the
English 43