Samsung Jet Bot VR50T95 Serie Benutzerhandbuch Seite 39

Voice Guide
The LiDAR sensor needs to be
reset. Turn the power off, then on
again. If that doesn't fix it, contact
Customer Service.
The 3D sensor needs to be reset.
Turn the power off, then on again.
If that doesn't fix it, contact
Customer Service.
The object recognition sensor
needs to be reset. Turn the power
off, then on again. If that doesn't
fix it, contact Customer Service.
The monitoring camera needs to
be reset. Turn the power off, then
on again. If that doesn't fix it,
contact Customer Service.
The AI processor isn't working
properly. Turn the power off, then
on again. If that doesn't fix it,
contact Customer Service.
Something's wrong with the main
system. Turn the power off, then
on again. If that doesn't fix it,
contact Customer Service.
Something's wrong with the
LiDAR bump sensor. The LiDAR
cap might be jammed, or there
might be something stuck in
there.
Can't move in this no-go zone.
Please move me somewhere else.
❇ ❇ You can find details of the check at the SmartThings App.
❇ ❇ When the Jet Bot is turned off and on again, it starts newly in the Auto Clean mode.
• There is a problem with the LiDAR sensor.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• There is a problem with the 3D sensor.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• There is a problem with the Object Recognition sensor.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• There is a problem with the monitoring camera.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• There is a problem with the AI system.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• There is a problem with the main system.
– Turn the power off, then on again. If the notice
remains, contact Customer Service.
• Bumper Sensor needs to be checked.
– Turn off the power switch and turn it back on.
– When the Status Indicator remains in red color, check
if there's any foreign matter between the LiDAR
sensor and the main body. If there is, remove the
foreign matter.
• The result of the location recognition indicates that the
Jet Bot is placed within the No-go Zones.
– Check the No-go Zones of the mobile App.
Checklist
English 39