Operating The Device - Xblitz PARK VIEW 2 Bedienungsanleitung

06. OPERATING THE DEVICE

1. Mount the camera and connect it to the power supply.
2. Put in a microSD memory card, formatted to FAT32 file system.
WARNING: the card should be put in and take out only when the device
is turned o .
3. Set the:
a. time and dat,
b. Loop recording (set the time of recordings). If you turn loop recording o , files will
not be overwritten,
c. Set the highest resolution available,
d. Set the G-Sensor to the lowest sensitivity available, so that the camera doesn't
save unnecessary video files when you drive on uneven roads.
4. Make sure that MOTION DETECTION and PARKING MODE are turned o . If they
remain turned on when you're driving, they will interfere with your recording.
Turning the parking mode on is recommended only when you leave your vehicle
parked.
PARKING MODE can be quickly turned on and o when recording by using the icon
on the main screen.
5. The camera will start recording automatically when you turn the engine
on (unless your car has a constant power supply in its lighter socket).
07. MAIN FEATURES OF THE CAMERA
1. Camera mode
The camera has 3 modes of operation. Recording mode: the camera records video.
Photo mode: the camera takes pictures. Video Play mode: browsing the footage
recorded by the camera.
2. Loop recording
The camera divides the recordings into files of length of your choice.
When the memory card is full, the oldest recording will be overwritten.
3. Resolution
The camera can record in many resolutions. The higher the resolution, the better
the quality of recordings, at the cost of more space on the memory card being taken.
It is recommended that you use the highest resolution available.
4. G-Sensor
Gravity sensor. When the sensor is turned on and your car is hit, the recording from
the event will be protected from overwriting. Using the lowest sensitivity setting
is recommended, as at higher settings the sensor can trigger when you drive
on uneven roads and fill up your memory card with files that won't be overwritten.
21
EN