Camera Assembly - Xblitz PARK VIEW 2 Bedienungsanleitung

05. CAMERA ASSEMBLY

CAMERA ASSEMBLY MANUAL
LIGHTER SOCKER
1. Instert the memory card into the camera.
2. Put the camera on your car's rear-view mirror.
3. Mount the camera with rubber fasteners included in the set.
4. Properly place the power supply cable and rear camera cable.
5. Connect the power supply cable and rear camera cable.
6. Connect the power supply to the car's lighter socket.
The placement of the additional camera depends on your preference. The camera
has a waterproof rating of IP67 (resistant to weather conditions).
ADDITIONAL CAMERA ASSEMBLY:
1. Connect the black cable included in the set to the AVIN port of the main
device, drag the cable towards the additional camera and connect them. Make sure
that the main device receives footage from the additional camera (if not, make sure
that the cable is connected to both ports properly).
2. Rear camera assembly: Connect the wiring that sticks out of the rear camera
to the power wiring of backup lights (red = plus). This will allow you to use
is as a backup camera.
3. The wiring placed on the outside of the vehicle should be properly insulated and
not tightly stretched.
20