Xblitz PARK VIEW 2 Bedienungsanleitung Seite 23

09. FAQ
1. The device doesn't turn on, the screen is flickering.
Charge the device's battery before using the device.
2. The device doesn't turn on/o automatically.
This can be caused by a constant power supply in the car's lighter socket.
3. The device restarts when driving.
Check the power supply.
4. The device doesn't record in loop (or records randomly)
Check the "Motion detection" and "Parking mode" settings - both should be turned
o when driving.
5. The device displays a "Memory card full" message.
Check "G-sensor" and "Parking mode" settings and set them to minimum.
The memory card should be formatted to FAT32 file system, first on a computer
and then in the camera.
6. The device records noise or distorted, unclear sound.
The device has a very sensitive microphone that records sound from
the surroundings. The recorded sounds can overlap. Air conditioning blowing air
on your front windshield can also a ect the sound recorded.
7. The device doesn't respond.
Press the RESET button or restore factory settings.
8. There are vertical stripes on the recording.
Wrong screen refresh rate setting. Change the frequency to "50Hz" or "60Hz",
depending on the local settings.
Due to constant improvement of our products, the manufacturer reserves the
right to making changes in the device and its set without prior information, some
of the functions described in this manual can slightly di er in reality.
WARNING: Use only the original charger with 5V power output.
(Do not connect directly to a 220V/230V power socket).
Not following the instructions can lead to damaging the camera
to dangerous situations.
WARNING! Playing files on a computer:
The camera does not have a mass memory drive mode. To play the
files on a computer, take the memory card out of the device and
use a memory card reader to connect it to a computer.
23
EN