Scope Of Supply And Equipment Variants; Scope Of Supply; Equipment Variants - HBK C2 Montageanleitung

3

SCOPE OF SUPPLY AND EQUIPMENT VARIANTS

3.1

Scope of supply

S
C2 force transducer
S
C2 mounting instructions
S
Manufacturing certificate
3.2

Equipment variants

All force transducers are available in different versions. The following options are avail­
able:
1. Nominal (rated) force
The C2 is available in different nominal (rated) forces (measuring ranges) of between
500 N to 200 kN
2. Cable length
Different cable lengths between 3 m and 20 m and a direct sensor on the mounted
M12 connector are available.
3. Connection variants (plug)
The force transducer can be ordered with various plugs, making it easy to connect to
HBM amplifiers:
- Free ends to the cable (amplifier with connection clamps, e.g. PMX, ClipX, etc.)
- D-Sub plug, 15-pin (MGC+, Spider8, Scout, etc.)
- D-SUB HD plug, 15-pin (many modules of the Quantum series)
- MS plug ME3106PEMV for devices of an older construction type, e.g. DK38
- Con P1016. Connection to the devices of the SomatXr series
4. TEDS transducer identification
You can order the force transducer with transducer identification ("TEDS"). TEDS
(Transducer Electronic Data Sheet) allows you to store the transducer data (character­
istic values) in a chip that can be read by a connected measuring device (with an
appropriate amplifier). HBM records the TEDS data before delivery so that no parame­
terization of the amplifier is necessary. (also see Chapter 8.1.5, page 18).
5. Integrated amplifier
Sensors from the C2 series can be ordered with an integrated amplifier. Versions with
an output of 0 to 10 V or 4 to 20 mA are available.
8
SCOPE OF SUPPLY AND EQUIPMENT VARIANTS
C2