Inhaltsverzeichnis
Werbung
4.2.2. Cutter Adjustment
The cutter depth has been adjusted from the factory and should not need to be
adjusted. If you find that mail is not being opened on cutter setting 1 and 2, the
cutter can be adjusted.
To adjust the cutter depth:
1. Set the Cut knob to the
should always cut standard mail deep enough to remove the contents but
not cut any of the contents. This position will be our reference for the
adjustment.
2. Remove the nip assembly cover (See
on page
44).
Operation
Omation® Series 210™ Envelopener® Operator Manual
"Standard
Cut" position (Figure 4-13). This position
No Cut
Figure 4-13: Standard Cut position
OPEX Corporation
Third Cut (deepest)
Second Cut (deeper)
Standard Cut
"Cleaning the Series 210 Envelopener"
(shallowest)
47
Werbung
Inhaltsverzeichnis
