Inhaltsverzeichnis
Werbung
5. Remove and empty the chip bin.
6. Vacuum loose paper chips and debris from the machine.
7. Use a cloth moistened with liquid cleaner to wipe down the exterior of the
machine.
- Use denatured alcohol on areas with stains, if necessary.
- Any non-flammable commercially available cleaning solution may be
used to clean the machine. When cleaning the Series 210 Envelopener,
DO NOT USE aerosol cleaners or compressed air because of the
flammable nature of many of these products. There is a risk of
equipment malfunction and/or injury associated with the use of aerosol
cleaners on OPEX equipment prior to the operation of equipment.
- When cleaning glass and plastic surfaces, use detergent-based
cleaners such as Fantastic™ or Formula 409™. Detergent-based
cleaners are recommended, because they do not cause component
degradation.
- Wipe dust and debris from the sensors. Debris build-up can cause jams.
Accumulations of dirt and debris can cover sensors, preventing them
from working effectively. This will hinder machine performance.
A cloth soaked with cleaning detergent or similar material should never be
used to clean an object such as a belt or roller when the belt or roller is being
driven by the system. Use of a cloth or similar material on moving
mechanisms can result in personal injury. If a belt, pulley or similar part
needs to be cleaned, it should be cleaned while stationary or unplugged.
8. Re-install the chip bin and nip arm cover.
46
Omation® Series 210™ Envelopener® Operator Manual
CAUTION
OPEX Corporation
Operation
Werbung
Inhaltsverzeichnis
