Warnings
Note:
After installation and replacement of the encoder, an acceptance test of the machine is to be
performed as specified by the manufacturer.
Mounting and commissioning is to be conducted by a qualified specialist under compliance with
local safety regulations.
Do not engage or disengage any connections while under power.
The system must be disconnected from power.
In addition to this, the machine manufacturer or designer himself must define the other data required
for final assembly (e.g. anti-rotation lock for screws required or not) for the respective application.
Information on mounting (e.g. optional checking of the shaft connection) must be specified by the
machine manufacturer or designer.
Avoid direct contact of aggressive media with the encoder and connector.
Do not clean the encoder with organic solvents like thinners, alcohol or benzine.
Encoders that have contributed to the failure of a safety function in the application must be
returned to HEIDENHAIN, together with the fasteners (screws).