Setting The Current Time; Warranty Disclaimer; Technical Data - Hama Mini Bedienungsanleitung

4.1 Programming on/off times
To program the switch-on times, the black tab is
pushed downwards according to the desired time.
1 tab equals 30 minutes. If a longer time span is
required, more tabs (30-minute intervals) must be
pushed downwards.
Switch-off times: Tab position > top

4.2 Setting the current time

The time selector dial is turned clockwise until the
arrow on the inner ring of the selector dial shows the
current time.
4.3 Connecting the timer to the mains,
connecting electrical appliances to the timer
Insert the plug of the timer into a 230 V earthed socket,
then insert the mains plug (IP44) of the electrical
appliance to be switched into the earthed socket of
the timer. The product may only be used indoors or
in protected outdoor areas (e.g. under eaves, in a
garage or similar).
The timer may only be operated in the position de-
scribed below. The socket must be at the top, the rotary
wheel for setting the time at the bottom.
5. Care and maintenance
Note
Disconnect the device from the mains before
cleaning and during prolonged periods of non-use.
• Only clean this product using a lint-free, slightly
damp cloth and do not use any harsh cleaners.

6. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.

7. Technical data

Mains connection
Connected load
Protection class
Protection
Switching intervals
Timer switch
230 V ~ / 16 (2) A
1800 W
1
IP44
30-minute cycle
3