Intended Use; Non-Intended Use - schellenberg ROLLODRIVE 75 PREMIUM Bedienungsanleitung

INTENDED USE

GB
This product (Item No� 22576/22578) is intended exclusively for the operation
of belt-driven roller shutter systems� Only use the product for the lifting and
lowering of smooth roller shutters with a permissible belt strap� For this, the roller
shutter system must comply with the technical requirements of the product�
Any other or further utilization beyond the explicitly specified shall be regarded
as not intended use�
Alfred Schellenberg GmbH shall not be liable for any consequential damage,
property damage and personal injury due to improper use�
According to EN 13659, it must be ensured that the displacement requirements
as per EN 12045 are met for the hanging material� When unrolled, the displace-
ment at the lower edge must be at least 40 mm at an upward-directed force of
150 N� It must be ensured that the travel speed of the hanging must be less than
0�15 m/s in the last 0�4 m�
The roller shutter system and its parts must be in a perfect condition� Defects in
the system or its parts must be repaired before installing the product�
An easily accessible 230 V / 50 Hz mains socket outlet must be available at the
place of installation�
The installation surface where the product is to be installed must be level and
suitable�
Only use original spare parts to avoid product malfunction or defects�
Improper running of the belt (belt guiding) may destroy the shutter belt and cause
unnecessary strain on the product� Install the product such that the belt enters
the shutter belt drive as vertically as possible� This will avoid unnecessary fricti-
on and wear�
Using too long belt straps can damage the product� Only use belt straps in the
permitted lengths�

NON-INTENDED USE

The use of the product for applications other than those mentioned above is not
permitted�
When using the product outdoors, there is a risk of a short circuit and electric
shock�
Never mount or operate the product outdoors�
Mechanical interlocks of any kind are not suitable for an automated operation
with the product�
15