Frigelux R4TT95BE Gebrauchsanweisung Seite 32


Door reversal instructions
CAUTION ! Unplug the appliance before you change the hinge position. Empty
the appliance. Carry out the change with at least 2 persons.
1. Remove the 2 cover caps on the worktop carefully with a small pointed object and
unscrew the 2 worktop-screws (fig. 1). Then unscrew the screws on the back.
Remove the worktop and the top hinge bracket (fig. 2).
2. Open the door a bit and remove it from the bottom hinge.
3. Tilt the appliance slightly backwards. A second person should hold the appliance
now so you have access to the bottom hinge.
4. Remove the 2 screws of the bottom hinge. Remove the adjustable foot on the left
and fix it on the opposite side (fig. 3).
5. Fix the bottom hinge on the opposite side.
6. Remove the sealing plug from the top left opening of the door und press it firmly
into the top right one.
7. Place the worktop upside down. Remove the hinge bracket (with axis, fig. 2) and
fix it on the opposite side. Do not tighten the screws too firmly.
8. Reinstall the door. Check, that the hinge axis meets its proper position in the
bottom left opening of the door.
9. Place the worktop on the appliance with the door closed. Check, that the top axis
meets the top opening (where the seal plug was). Fasten the 2 top screws first
and then the screws on the back slightly. Adjust the worktop properly. Check, that
the door is adjusted perpendicularly.
10. Now tighten all 4 screws of the worktop. Do not tighten the screws too firmly.
fig. 1
Remove the worktop by removing the 2 screws
on the top and the two screws on the back.
Remove the 2 cover caps on the top with a
small flathead screwdriver before.
fig. 2
Remove the hinge and fix it on the opposite side.
Do not tighten the screws too firmly.
32