Frigelux R4TT95BE Gebrauchsanweisung Seite 31


Refrigerator upgrade
Make sure the refrigerator is level. Use the rotatable adjustable feet at the front. If the refrigerator is
not level, the doors and magnetic sealing alignments will be affected and may cause malfunctions.

Do not turn on the refrigerator for 4 hours
After any movement, it must not be connected for 4 hours. This delay allows the coolant to be
adjusted.

Installation
Let your device breathe. Heat is released from the walls so it is important to leave a circulation of air
around your device.
Energy saving tips

The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.

Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.

Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.

Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.

Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Turn off your appliance

If the unit is not likely to operate for a long period of time:

Remove all food from your appliance from the refrigerator.

Switch off the appliance by setting the thermostat to position 0.

Unplug the appliance.

Clean it thoroughly.

Keep the door open to prevent odors from

Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be changed
by the consumer. The lifetime of these LEDs is normally sufficient for no change to be made. If
however, and despite all the care taken during the manufacture of your appliance, the LEDs
were defective, please contact your after-sales service for any intervention.
rising.
31