Intended Use - Becker CentronicPLUS SWC541 PLUS Montage- Und Betriebsanleitung

The transmitter described in these instructions must only be used indoors for
the operation of radio drives and radio control units that are compatible with
the CentronicPlus.
Attention
A safety-relevant function has been provided for the
thresholds. Setting the threshold values wrongly can cause
damage to the sun protection system. For that reason, set-
ting the threshold values for the safety of your sun protection
system should only be done by – or under the instruction of –
a specialist retailer.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
• Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
•
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
•
Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

23 - en