Husqvarna S 13 Bedienungsanweisung Seite 8

When you use the dust extractor together with another
machine, there is an electrical outlet on the dust
extractor. Connect the machine to this outlet. Then when
you start it up the dust extractor will also start after
approximately 1-2 seconds. When you turn it off, the
dust extractor will continue to run for approximately 10
seconds to empty the hose and then stop.
To install a new Longopac dust bag
WARNING:
before you replace the Longopac dust bag.
1. Put the Longopac dust bag in the holder.
2. To attach the Longopac dust bag holder, twist the
Longopac dust bag holder until the pins engage in
the slots.
8
Always clean the prefilter
3. Pull the Longopac bag up from the holder and put it
around the container.
4. Tighten a strap around the Longopac dust bag and
the container to attach the bag correctly to the
container.
5. Pull the Longopac dust bag down on the outer side
of the bag holder.
6. Close the bottom of the Longopac dust bag with a
cable tie.
To clean the filter
CAUTION:
pre-filter needs to be replaced. If suction still
remains poor afterwards, the HEPA filters
need to be replaced. See instructions in
change the HEPA filter on page 10 .
If suction remains poor, the
896 - 005 - 01.12.2022
To