Special Safety Regulations - Hendi 860083 Gebrauchsanweisung

• Always turn the appliance off before disconnecting the plug.
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.

Special safety regulations

• Do not use any extra devices that are not supplied along with the appliance.
• Caution! Make sure the cord does not come in contact with hot components while using
the appliance.
Intended use
• This appliance is intended for professional use.
• The appliance is designed only for keeping soup
hot. Any other use may lead to damage of the ap-
EN
pliance or personal injury.
To use :
• Fill the tank with sufficient water. Empty trays
should just float.
Important: Always ensure that there is sufficient water in the tank! Check this regularly, also during use.
Maintenance advice:
• Always remove the plug from the power point
before cleaning.
• If used intensively, regularly remove lime scale
from the bottom of the water tank
• Never immerse the appliance in water or any
other cleaning fluid
Faults:
Fault
Appliance does not work
Appliance does not reach the set temperature
4
• Operating the appliance for any other purpose
shall be deemed a misuse of the device. The user
shall be solely liable for improper use of the de-
vice.
• Use the thermostat knob to set the desired pow-
er level.
• Clean the appliance with a damp cloth
• Never use aggressive or corrosive cleaning
agents
• Avoid as much as possible water contacting the
electrical components
Possible cause
No power at the power point
The plug is not plugged (correctly) into the power point
Heating element faulty
Control unit faulty
Heating element fuse faulty
Possible solution
Check the fuse
Check the plug
Contact the supplier
Contact the supplier
Contact the supplier