Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CCE – Cash Concepts Europe GmbH & CCE GmbH
von-Behring-Straße 6a – D-88131 Lindau / Germany
Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20
Email: info@cce.gmbh / Web: www.cce.gmbh
Factory Setting
To load the factory settings, press and hold the CUR button when starting the machine until the Flash Disk Format Finish display
appears. Then release the button and press RESET. The factory settings have been loaded.
Error management
The CCE 3080 is equipped with a comprehensive error management system to inform you about problems with money processing
and counterfeit detection, but also to draw your attention to soiled sensors. Please pay particular attention to the instructions for
cleaning the machine in order to exclude errors caused by contaminated sensors and to have an optimal result when counting
banknotes.
In the event of an error, you will receive an error message in the display. If an error message keeps reappearing even after cleaning
and correct use, please contact your dealer.
Banknote recognition error
In general, please check whether the following faults can be remedied by thorough cleaning before contacting technical support.
Error CODE
UV Error
1. Note suspected of being
counterfeit
2. Error in UV detection
MG Error
1. Note suspected of being
counterfeit
2. Error in MG detection
IR Error
1. Note suspected of being
counterfeit
2. Error in IR detection
Image Error
1. Note suspected of being
counterfeit
2. Error in DD / Image Board
detection
Double
1. Note suspected of being
counterfeit
2. Several notes withdrawn
Half
1. Note suspected of being
counterfeit
2. Banknote damaged or folded
Chain Note
Several notes withdrawn
Slant
Several notes withdrawn
Denomination
Errors in the valuation
Different
P a g e
| 10
Information
1. Please check the suspect banknote for authenticity
2. Please check if the selected level of the UV check is set too
high.
1. Please check the suspect banknote for authenticity
2. Please check if the selected level of the MG check is set too
high.
1. Please check the suspect banknote for authenticity
2. Please check if the selected level of the IR check is set too
high.
1. Please check the suspect banknote for authenticity
2. Please check if the selected level of the DD check is set too
high.
1. Please check the suspect banknote for authenticity
2. Please check whether the banknotes are sticking together
3. Please check the contact pressure of the feeder
1. Please check the suspect banknote for authenticity
2. Please check if the note is damaged, creased or folded.
1. Please check whether the banknotes are sticking together
2. Please check the contact pressure of the feeder
1. Please check whether the banknotes are sticking together
2. Please check the contact pressure of the feeder
1. Please check if a deviating denomination was detected in
the sorted mode.
Solution
E n g l i s h
Werbung
Inhaltsverzeichnis
