Safety Instructions; Technical Data; Timer Function - EKVIP 022507 Bedienungsanleitung

SAFETY INSTRUCTIONS

• Do not connect the product to a power
point while the product is still in the pack.
• Intended for indoor and outdoor use.
• Check that no light sources are damaged.
• Do not connect two or more string lights
together electrically.
• No parts of the product can be replaced,
or repaired.
The whole product must be discarded if
any part is damaged.
• Do not use sharp or pointed objects
during assembly.
• Do not subject the power cord or wires to
mechanical stress. Do not hang objects on
the string light.
• This is not a toy. Be careful if using the
product near children.
• Disconnect the transformer from the power
point when the product is not in use.
• This product must only be used together
with the supplied transformer and must
never be connected directly to the mains
supply without a transformer.
• The product is not intended to be used as
general lighting.
• The LED light sources are not replaceable.
When the light sources have reached the
end of their useful life the complete
product must be replaced.
• Recycle the product at the end of its useful
life in accordance with local regulations.
WARNING!
The string of lights may only be used if all
seals are fitted correctly.
SYMBOLER
Read the instructions.
Approved in accordance with
the relevant directives.
Safety class II.
Recycle discarded product as
electrical waste.

TECHNICAL DATA

Rated voltage
Output
No. of LEDs
Protection rating
Cord length
Size
USE
1. Plug the plug into a power point.
The string light goes on and shines
constantly.
2. Press the switch to activate the double
timer function. The switch goes green
when the timer is activated.
3. Press the switch again to switch off the
string light.

TIMER FUNCTION

The product has a double timer that controls
the string light as follows – on 8 hours,
off 6 hours, on 2 hours and off 8 hours.
230 V ~ 50 Hz/31 VDC
6 W
160
IP44
5 m
L16 m
EN
7