Start-Up; Removing Iso-Strips; Inserting/Changing The Battery; Operation - ADE Franca Bedienungsanleitung

Start-up

Removing iso-strips

The battery is already inserted upon delivery and fitted with an iso-strip to prevent it
from discharging ahead of time. In order to start up the scale, you must remove the
iso-strip.
The battery compartment is located on the underside of the device.
1. Push the locking tab slightly towards the battery compartment cover.
2. Lift the battery compartment cover slightly and pull out the iso-strip.
3. Replace the battery compartment cover. Make sure the locking tab clicks back
into place.

Inserting/changing the battery

For use, you need a 3 V CR2032 battery.
1. Open the battery compartment and remove the old battery.
2. Slide the battery against the contact springs under the large, square retaining tabs
and then press it downwards. The battery clicks into place under the opposite
retaining lugs so that it sits firmly in its holder. Pay attention to the correct
polarity (+/-). The plus pole (+) must point upwards.
3. Replace the battery compartment cover.
Suggestions for changing the battery:
‚ The batteries need to be changed when "Lo" or nothing is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Dispose of old batteries in an environmentally appropriate way
(see "Disposal").

Operation

Weighing

1. Place the scale on an even, firm and dry surface. Carefully position the scale in order
to avoid hard shocks to the sensors/feet and therefore any damage.
2. If necessary, place the measuring cup on the weighing surface, as described in
"Removing/placing the measuring cup".
3. To turn on the scale, briefly press the ON/OFF/TARA button.
4. Wait a moment until the display shows "0" permanently.
KE 919 kitchen scale
Start-up
17