Start-Up; Removing Iso-Strips; Inserting/Changing The Battery; Operation - ADE Claire Bedienungsanleitung

Start-up

Removing iso-strips

The battery is already inserted upon delivery and fitted with an iso-strip to prevent it
from discharging ahead of time. In order to start up the scale, you must remove the iso-
strip. The battery compartment is located on the underside of the device.
1. Open the battery compartment by pushing the locking tab towards the battery
compartment cover and then remove this cover.
2. Pull out the iso-strip.
3. Replace the battery compartment cover.
The locking tab must snap audibly into place.

Inserting/changing the battery

For use, you need a 3 V CR2032 battery.
1. Open the battery compartment by pushing the locking tab towards the battery
compartment cover and then remove this cover.
2. Remove the old battery.
3. Push the battery against the spring contacts under the square retaining tabs and
then press it in. The battery should fit into the opposite retaining tabs so that it is
firmly secured inside the compartment.
Pay attention to the correct polarity (+/-). The plus pole (+) must point upwards.
4. Replace the battery compartment cover.
The locking tab must snap audibly into place.
‚ The batteries need to be changed when "Lo" or nothing is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Dispose of old batteries in an environmentally appropriate way (see
"Disposal").

Operation

NOTE on material damage
− Only cut on the chopping board, not on the scale's weighing surface.
This could damage the sensitive electronics as well as its surface.
The scale must be fully pulled out of the chopping board for use.
KE 2102 kitchen scale
Start-up
17