LG RESU16H Prime Installationsanleitung Seite 8

Standing bracket 1
Standing bracket_1
Battery Module B
n t
F r o
R e a
r
SH128064P8S8XXX
Label
Wall
Battery Module Direction
R e a
n t
r
F r o
Battery Module A
F r o
n t
F r o
SH128064P8S8XXX
Label
Wall
Battery Module B
Rear
Front
Battery Module A
TOP VIEW
Module Support BRKT
8
3. Remove the Drill template. Then pre-
tighten the fasteners on the Standing
Bracket 1.
* The fasteners will be fully tightened
in a later step.
4. Place Battery Module B on the rear
side of Module Connect plate.
* The side without bolts is the front
of the Battery Module.
*
battery pack is of B. Label is
attached on the left side of Battery
Module.
5. Place Battery Module A on the front
side of Module Connect plate. The
Rear side of each Battery Module
should face each other. After that,
remove the Spacer between the wall
and Battery Module.
*
Battery pack is of A. Label is
n t
attached on the left side of Battery
Module.
6. Loosely assemble Module Support
BRKTs using 6 bolts each (Please do
not tighten the bolts all the way).
bolts (x12) with a torque of 5 N·m
(3.7 lbf·ft).
Battery Control Unit
Battery Modules
Spacer
TOP
Spacer
(used for assmbly ang disassembly)
Spacer Spacer
TOP VIEW
Battery Control Unit
Battery Control Unit
n t F r o
F r o F r o
n t
n t
F r o n t
Sensing connector Sensing connector Power connector Power connector
"Click!" TPA
TPA
7. Remove bubble wrap from
connectors of Battery Control Unit
and the warning label of Battery
Modules.
8. Place the spacers on the position
marked with label on Battery
Modules.
9. Place the Battery Control Unit on
top of the spacers, and align with the
Battery Module.
* Be careful not to break the
connector between the spacers and
the Battery Control Unit.
10. Connect the power and sensing
connectors on the right and left sides
(2 each). Assemble the connectors
until you hear a "Click". After that,
lock the power connector by pressing
TPA (Terminal Position Assurance).
* Assembly both sides of sensing
connector one by one so that both
sides make a "click" sound.
* Be careful if you can't hear the
"click" sound, it may not be fully
assembled.