LG RESU16H Prime Installationsanleitung Seite 13

3.2.2.5 QR Code Scan
The QR code scanning method is as follows.
Select
Prime: Fixed at 2
FLEX: Select from 2 to 4
S/N of consecutive QR
codes are automatically
displayed(Maximun 5)
When the QR code registration is complete, click the "Next" button.
If the scanned serial number matches the actual serial number, it will proceed to the next
section.
There are three (3) QR codes: Battery Control Unit, Battery Module A, and Battery Module B.
EH257064P8S8XXX
SH128064P8S8XXX SH128064P8S8XXX
Wall Wall
Wall Wall
3.2.2.6 External Internet Connection
"Next" button.)
1. Battery Control Unit QR Code
2. Battery Module QR Code
3.2.2.6.1 Ethernet Connection (primary)
Connect the ethernet cable to a router with internet access.
* For the ethernet cable connector location, refer to the image below.
Connector for
Ethernet cable
For ethernet use, it is enough to connect the cable. Since you have already connected the cables
3.2.2.6.2 Wi-Fi Connection
If you are using an ethernet connection and do not wish to use Wi-Fi, simply click the "Next"
button.
Scan AP(1): Wi-Fi-network currently available for connection is displayed in 2.
SSID(2): Enter the name of the Wi-Fi-network to connect (You can enter it
manually without going through 1.).
Password: Enter the password of the Wi-Fi-network to connect.
When internet connection is successful, click the "Next" button.
* In case the WLAN connection is unstable, enhance the signal by using a WLAN
repeater.
13