LG RESU16H Prime Installationsanleitung Seite 10

Handle
Front Cover
M5 PH Bolt 6ea
Front Protection Cover
Hole #2
Hole #1
Internal cable
Hole #2 Communication cable
Hole #1 Power cable
10
20. Open the front cover.
* Hold the handle and turn it
counterclockwise.
21. Loosen 6 bolts and remove the Front
Protection Cover.
* Be careful not to drop the bolts into
the pack at this stage.
22. Assemble the adapter or cap
according to regional regulations.
Insert the RMD ethernet cable
through Hole #2 and connect the
cable. Then proceed to Section 3.2
Installation for Remote Monitoring
23. Assemble the adapter or cap
according to regional regulations.
Then insert the power and
communication cables through the
holes from outside of the pack.
* Arrange the internal cable as
required to avoid blocking the holes
for external cables.
* Assemble custom gland (AU only)
according to regional requirement.
With custom gland, remove blank
cables, do not leave open hole
24. Connect the cables according to their
application.
* Refer to Section 3.3 Cable
Connections.
Front Protection Cover
M5 PH Bolt 6ea
Handle
Handle
25. Arrange the power cables and
communication cables separately
using cable ties.
* Leave no gap between the cables
and the conduit knock out to
prevent foreign materials from
entering the battery pack.
* Apply silicone sealant or putty
around the cables at each outer
cable connection hole to prevent
foreign materials from entering the
battery pack
* For Australia only, silicone sealant
or putty is not required.
Instead, required art is Cobalt Solar
Custom Gland, part number CSE-
CHG-3/4NPT-H3-5.5-1B (pack
of 2). Available from your RESU
distributor.
26. Re-attach the Front Protection Cover
with M5 PH bolt 6ea.
27. Close the front cover.
* Hold the handle and turn it
clockwise.
* Make sure the Front Cover is
closed.