Makita DHP484 Betriebsanleitung Seite 9

NOTE: The tool automatically stops if you keep pulling
the switch trigger for about 6 minutes.
Lighting up the front lamp
► Fig.4:
1. Lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being
pulled. The lamp goes out approximately 10 seconds
after releasing the switch trigger.
NOTE: When the tool is overheated, the tool stops
automatically and the lamp starts flashing. In this
case, release the switch trigger. The lamp turns off in
one minute.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
► Fig.5:
1. Reversing switch lever
Adjusting the fastening torque
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may
damage the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the
neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation. When the reversing switch
lever is in the neutral position, the switch trigger cannot
be pulled.
Speed change
► Fig.6:
1. Speed change lever
CAUTION:
Always set the speed change lever
fully to the correct position. If you operate the tool
with the speed change lever positioned halfway
between the "1" side and "2" side, the tool may be
damaged.
CAUTION:
Do not use the speed change lever
while the tool is running. The tool may be damaged.
Displayed Speed
Number
1 Low
2 High
To change the speed, switch off the tool first. Push the
speed change lever to display "2" for high speed or "1"
for low speed but high torque. Be sure that the speed
change lever is set to the correct position before
operation. If the tool speed is coming down extremely
during the operation with display "2", push the lever to
display "1" and restart the operation.
Selecting the action mode
CAUTION:
Always set the ring correctly to
your desired mode mark. If you operate the tool
with the ring positioned halfway between the
mode marks, the tool may be damaged.
CAUTION:
When you change the position from
" " to other modes, it may be a little
difficulty to slide the action mode changing ring.
In this case, switch on and run the tool for a
second at the "
and slide the ring to your desired position.
► Fig.7:
1. Action mode changing ring 2.
Adjusting ring 3. Graduation 4. Arrow This tool has
three action modes.
•
Drilling mode (rotation only)
•
Hammer drilling mode (rotation with
hammering)
•
Screwdriving mode (rotation with clutch)Select
one mode suitable for your work. Turn the
action mode changing ring and align the mark
that you selected with the arrow on the tool
body.
► Fig.8:
1. Action mode changing ring 2. Adjusting
ring 3. Graduation 4. Arrow
9 ENGLISH
Torque Applicable
High
Low Light loading
" position, then stop the tool
operation
Heavy
loading
operation
operation