Installing Accessories - Atlas Copco ETV STR61-25-10 Produktanweisungen

Installation
Preventing ESD problems
The components inside the tool and controller are sensitive to electrostatic dis-
charge. To avoid future malfunction, make sure that service and maintenance is
carried out in an ESD approved work environment. The figure below shows an
example of an appropriate service work station.

Installing accessories

Disassemble of the tool and/or accessorie must only be performed by qualified
maintenance personell.
This device emits CDRH/IEC Cl ass 2 laser and IEC Class 1M light. Do not
stare into the beam.
Make sure the tool is disconnected from the cable before disassembling.
Required tools:
• Adjustable spanner
• Screwdriver
1. Put the front part in a clamping jaw (choose a suitable size) and fasten the
clamping jaw in a vise.
2. Loosen the front cap nut using an adjustable spanner. Remove the tool
from the vise.
3. Pull out the angle gear carefully from the tool.
4. Remove the following parts from the angle gear housing:
1. the lock ring (keep for later use)
the sealing washer (to be discarded)
2.
the front cap nut (to be discarded)
3.
6
EN
© Atlas Copco Industrial Technique AB - 9836 742100 00
ETV STR61-25-10