Before The First Use; Filling The Water Tank; Ironing Tips - Zelmer ZIS5400 Aqua Steam Benutzerhandbuch

EN
PL

BEFORE THE FIRST USE

Before using the Steam Station, please ensure you read the user manual and understand all parts and
features of the Steam Station. Be sure to remove any packaging material and labels before using for the
first time.
In the first use they can break off odors or fumes that sent quickly. Do not spray for the first time on clothes
and there may be traces of dirt on the soleplate.
WATER TO BE USED
The device is designed for use with tap water. If the water in your area is hard or semi-hard use mix tap
water with distilled or demineralized water purchased in stores, in the ratio 2:1 and 1:1 respectively (distilled
water: tap water). Check with your water supplier to determine the type of water in your area.
Never use 100% distilled or demineralized, rain water, softened water, scented water, water from other
appliances such as refrigerators, air conditioners, dryers or other types of home water preparation water.

FILLING THE WATER TANK

Fill it through the water inlet cover. Do NOT fill over the MAX level indicator. Make sure when placing it back
to the station that it fits correctly.
OPERATING INSTRUCTIONS
NB: If it is the first time you have steam-ironed or if the product has not been used for some time, turn the
temperature control to Max position and press the steam button continuously until steam comes out. This
process can take a few minutes.
Place the Steam Station on a firm level table, bench or ironing board. Plug the unit into a power outlet and
switch on at the power point.
Adjust the temperature dial in terms of choose the kind of fabrics that you want to iron. Note: If you want to
use the steam ironing, we suggest you to adjust the temperature dial on MAX. When the iron operating light
indicator goes out the device will be ready for use.
Note: During the whole operating time, the iron operating light indicator will go on and off in erratic intervals,
this is normal.
To make the steam jet come out, press the steam trigger, and if you want to stop the steam release the
steam trigger, in a few seconds steam will stop.
Pressing and holding the steam button, the steam can jet out from the iron soleplate. The steam can be
switched off at any time by releasing the steam button.

IRONING TIPS

• Start with the fabrics to be ironed at a low temperature and finish with those that need higher temperatures.
• For mixed fibre fabric, set the ironing temperature to a lower setting.
• For woollen garments, press the steam trigger repeatedly over the garment without physically touching it
with the iron.
• For thicker fabrics, raise the iron temperature at MAX position.
IRONING GUIDE CHART
Below is a guide on the temperature setting required for different types of fabric, along with the recommended
iron method.
11