Inhaltsverzeichnis
Werbung
UP
First time use / reset mode
The first time you apply power to the control unit, the height adjustment can only be operated in the reset-
mode.
As long as the reset-mode is enabled, the system can only move downward. To end the reset-mode and use the
system normally, please follow the next steps:
•
Press and hold "up-" and "down-" simultaneously more than 3 seconds
-> Legs begin to move slowly downward.
•
Keep pressing "up" and "down"
-> Legs move down to the lowest position and rebound 2-5 mm, then stop.
•
Release "up-" and "down-" together
-> Initialization is completed.
The system can be operated normally now. To adjust to the desk to the desired height simply press and hold the
up or down button, once released the adjustment stops.
Saving height positions
To save different height positions, move the frame to the desired height.
•
Press the "S" key
-> The display starts flashing, now quickly press one of the number keys. The position is now
permanently saved on the corresponding number key.
Adapt displayed height
First set the table height as desired, lowest position is recommended. Measure the actual height (floor to top
edge of the table top). Write down the height in centimeters (or inches if your system uses the imperial number
system).
•
Touch and hold "S" directly followed by "UP" for about 6 seconds.
-> The first number starts blinking.
•
Release both buttons and press "UP" or "DOWN" to increase or decrease the value. In metric values, the
first number will usually be a zero and does not require any adjustment, continue with the next step.
•
Press the "S" key again.
-> The second number starts blinking.
•
Press the "UP / DOWN" buttons as noted above to change the value.
•
Tap the "S" button
-> Third number starts blinking.
•
Press "UP / DOWN" buttons as noted above to change the value.
•
Finally press the "S" key.
-> The setting is saved, the process is now complete
Change the display in metric or imperial value
•
Touch and hold the "S" key, immdiately followed by "DOWN" and hold both for approx. 4 seconds.
-> The height display is now changed and saved between CM and INCH depending on the default setting.
Container stop setting
This function is used to limit the height adjustment function; once the table has been set, it cannot normally be
moved below the set stop point.
•
Move the frame to the position you want for the stop point.
•
Touch and hold the "S" key, immediately followed by "1" and hold both for approx. 4 seconds.
-> The letter "_L_" is now displayed. This means that the table is locked in the lowest position, to which
it can be moved.
•
Release the keys
-> The setting is saved and the process is now complete
Handset with memory function
Nowy Styl - eUP 3 EN - DE - PL
15
EN
EN
DOWN
-
Werbung
Inhaltsverzeichnis
