Removing Stains - Extremis AMAi Bedienungsanleitung

ment. 0. Remove all residues of old applications.
MACHINE SANDING
Only every 2 to 4 years
After a few years, there will be little cracks and ma-
ybe some warping in your wood. This is completely
normal, because wood is a natural, living material.
Solid wood has the great benefit that you can sand
away the top layer to make the surface smooth and
flat again. You can do this every two to four years
with a hand-held sander. Do it on a dry day. Use 120-
grit sandpaper for this.
REPLACING A WOODEN PART
Hey! You don't need to be an engineer to understand
our products. And you don't even need to be great
at DIY to replace a part. Do make sure that you can't
repair the damage simply by sanding the slat.
Soft desktop
CLEANING
Regularly
Remove dust and fingerprints using a microfibre
cloth. Remove small stains using a cleaning cloth
and spray cleaner/indoor surface cleaner.
Clean badly soiled panels wet all over. Use a cle-
aning cloth and water containing indoor surface
cleaner to wet the surface. Then dry with a well-rin-
sed and wrung-out cloth.

REMOVING STAINS

Only if nothing else helps
Remove stains as soon as they occur! Remove cof-
fee, tea, alcohol immediately before the substances
begin to act on the tabletop. Take precautions by
using coasters.
Oak veneer
CLEANING
Regularly
Dust regularly using a lightly dampened cloth in the
direction of the wood grain, never across the grain.
Wipe dry with a soft cloth immediately afterwards.
Do not use too much water and, above all, do not le-
ave any residual water. Do not use abrasive cleaning
agents or aggressive solvents!
In case of spillage of soft drinks, beer, coffee, tea,
wine, etc. and even water
Soak up the liquid immediately with a damp cloth
and dry the area with a dry cloth or chamois leather.
Use a soft cloth and particularly not paper towels.
These can scratch the surface. Shrinkage or staining
caused by moisture are therefore not covered by the
guarantee.
Watch the maintenance video on
our website:
www.extremis.com/maintenance
55