Maintenance And Care; Spare Parts And Accessories; Disposal Information; Declaration Of Conformity - Flex IW 1/2" 750 18.0-EC Originalbetriebsanleitung

IW 1/2" 750 18.0-EC
of the bolt head or nut is fully engaged into
socket.
■ Depress the variable-speed trigger switch
to turn the impact wrench on. Once the
fastener is loose, the tool will stop running.
This tool also allows you to continue to
depress the trigger switch for removing the
nut from the long bolt, if necessary.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior and
motor with dry compressed air.

Spare parts and accessories

For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options!

-Declaration of conformity

We declare on our sole responsibility
that the product described in "Technical
specifications"conforms to the following
standards or normative documents:
EN 62841 in accordance with the regulations
of the directives 2014/30/EU, 2006/42/EC,
2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
15.06.2022; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Klaus Peter Weinper
Head of Quality
Department (QD)
19