Maintenance And Care; Disposal Information; Transport - Flex DW 45 18.0-EC Originalbetriebsanleitung

DW 45 18.0-EC
6. Switch on the power tool.
The screw is screwed into the workpiece
until the set screw-in depth is reached.
Check screw-in depth, change if required.
NOTE!
When the preset screw-in depth is reached,
the drive is disengaged, the screwdriver bit
stops turning
7. When you have finished fixing screws,
switch off the electric power tool.
At the end of work:
8. Move the direction of rotation selector (3)
to the middle position.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool
CAUTION!
Before performing any work on the electric
power tool, move the lever for selecting
direction of rotation (3) to the middle
position.
Cleaning
CAUTION!
When cleaning with compressed air, always
wear goggles.
Regularly clean the power tool and

ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior

and motor with dry compressed air.
Regularly blow out screw magazine with

dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
.

Disposal information

WARNING!
Render redundant power tools unusable:
- mains operated power tool by removing
the power cord,
- battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools
into the household waste! In
accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!

Transport

The equivalent lithium content of the batteries
included in the product package is below the
appropriate limit values.
Therefore the battery as an individual com-
ponent as well as the power tool and its product
package are not subject to national or
international dangerous goods regulations.
If several machines with lithium ion batteries
are transported, these regulations may
become relevant and special safety measures
may be required (e.g. for the packaging).
In this case find out about the currently valid
regulations for the country of use.
27